Three steps, roughly ten seconds. Open the box, open the sachet, peel the film.
- Take one sachet from the box. Each liner comes individually wrapped, which is the reason one lives in a jacket pocket or a gym bag without turning into lint. Printed instructions sit inside every box, so the first time isn't guesswork.
- Open the sachet and unfold the liner.
- Place it, and go. This is the only step that differs between the two.
For DRY: peel the film off the back and press the disc into the front of your underwear, quilted side up. The adhesive strips grip the fabric. Briefs, trunks and boxer briefs hold it best, because there's tension in the fabric for the adhesive to work against.
For SHIELD: fold it in half along its length and set it in place. There's no adhesive and no film to peel. It's held by its own fold and by the shape of your underwear around it, which is why the fold matters more than the exact position. Get the fold right and it stays.
You can wear both at once. Most men who do put them on in the same ten seconds and stop thinking about it.
When you're done, wrap it and bin it. Don't flush it. Absorbent liners are built to hold liquid rather than release it, and plumbing takes that personally.
See how DRY works: mysureway.com/dry